Your Cart
Warehouse Open for Click and Collect orders
Mon - Fri (1630 - 1800)   Sat(0900 - 1230)

Kakute AIO

Kakute AIO
Kakute AIO
Kakute AIO
Kakute AIO
Out Of Stock
Kakute AIO
Kakute AIO
Kakute AIO
Kakute AIO

With FC, OSD, PDB all integrated, Kakute AIO makes it simple and convenient to build up your drone.Only one VTX module is needed to make a complete set of FPV Racing Drone.Minim OSD integrated; MWOSD Firmware preloaded; OSD Config port available; OSD interface highly customizable according to you own needs.

2 oz Copper PCB ensures the 120A Maximum Continuous Current.Dedicated Boot button for easy firmware flashing.Reinforced solder pads for trouble-free direct soldering.Extremely low profile design.

Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).PDB Maximum Continuous Current 120A.VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.Filtered voltage output - output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX. 5v/3.3v RX selectable.

Cleanflight support (RACE target).BLHeli flashing supported by hardware.Raceflight and.Betaflight ready

Package Includes

1x Kakute Flight Controller 

1x Quick Start Guide 

1x 80mm XT60 connector wire 



STM32F303CCT6(256kB flash) 32-bit processor 

MPU6050 Gyro/Accelerometer 

ATmega328P with Arduino Bootloader(minim OSD) 

MAX7456 Monochrome On-Screen Display(minim OSD) 

FTDI Cable Compatible Pinout(minim OSD) 

High quality, gold plated PCB 

Micro USB connector for programming 

Dimensions: 36x47.5x7mm (includes USB in height) 

Mounting Holes: 30.5mm square to center of holes

Weight: 7g 

Write a review

Please login or register to review