Menu
Your Cart

Pickup from Wangara Warehouse available - Mon-Fri 1630 to 1800 or Saturday 0900 to 1230
other times available - just make an appointment


Matek M8Q-CAN GPS (Includes QMC5883L Compass)


GNSS M8Q-CAN, UAVCAN & MSP


Specifications

  • ArduPilot AP_Periph F303 CAN node
  • GPS SAM-M8Q (GPS, GLONASS, Galileo)
  • Magnetic Compass QMC5883L
  • Barometer DPS310
  • UART1, Firmware update
  • UART2, onboard GPS
  • UART3, MSP Protocol
  • CAN, UAVCAN Protocol
  • I2C, onboard QMC5883L & DPS310
  • I2C JST-GH connector, external AirSpeed sensor
  • CAN bootloader LED, Blue
    • Fast blinking,  No communication between CAN node and Flight Controllers
    • Slow blinking, Communicating between CAN node and Flight Controllers
  • GPS PPS LED, Green
    • blinking(1Hz) when GPS has 3D fixed
  • Boot button
  • Input voltage range: 4.5~5.5V (5V pad/pin)
  • Power consumption: 100mA
  • Operating Temperatures: -20~80 °C
  • 29mm*29mm*9.7mm
  • 11.3g

Includes

  • 1x M8Q-CAN
  • 2x JST-GH-4P to JST-GH-4P 20cm silicon wire

Tips

  • u-blox M8Q series has no external flash memory
  • Compass Alignment(Arrow forward and flat mounting):
    Ardupilot/Mission Planner: Rotation None
  • Make sure to have compass/magnetometer 10cm away from power lines/ESC/motors/iron based material
  • The scratches on ceramic antenna are the result of tuning the antenna by ublox.
  • HD cameras(Gopro, Split, Tarsier, etc) could interfere GPS signal, try turning off HD camera before GPS 3D fix

Write a review

Please login or register to review