Optical Flow Sensor for APM2.52 APM2.6 Flight Controller Note: Please open the lens before use, remove the protective film Cannot focus closer than 30cm - Can Adjust Focal length to achieve better result..
MinimOSD Rev. 1.1 OSD Description: On-Screen Display Ardupilot Mega MinimOSD Rev. 1.1 OSD diy drones APM2 APM2.5 APM2.6 APM has an companion OSD board called MinimOSD. It reads all the MAVLink data in the APM telemetry stream and overlays it on the video stream if you're using an on-board camera and..
With this cable and a compatable android phone you can adjust your flight controllers settings and pids - even flash new firmware.
Leave your laptop at home a grab an OTG cable
This small bluetooth module allows you to connect wirelessly to your flight controller from your android phone / tablet or your pc
â€¢ Read and Write PID
â€¢ Setting switch adjustment for AUX1 and AUX2
â€¢ Monitor receiver signal and FC output signal
â€¢ Monitor all sensor..
Description: - The LED indicator is for APM/MegaPirate. There are four 3W led White/Red/Green/Bule on the board, and it can be setting light up method in Mission Planner. - The LED Indicator supported 5~30V input. Specification: - Dimension: 57 x 20 x 8mm - Weight: 10g..
Ultrasonic sensor for use in Arduino projects to measure distance, can be used with Multiwii boards / megapirate / Arducopter. Really easy to add to the Naze32 in baseflight and cleanflight - great for Carpark racing : ) Works better indoors or on flat surfaces - grass can reflect with angles great..
Can use this tool to program the Eachine Pro 5.8 to add on the Achilliez firmware
Explore new microcontroller worlds with an ST-Link Programmer & Emulator / Debugging dongle. This little USB stick contains a microcontroller with the code for ST's classic programmer/emulator for STM8 and STM..
Simple grommets to completely isolate your flight controller from the frame.
require most flight controller holes to be drilled out to 4mm to seat the grommets.
check that your flight controller can be drilled out to accommodate - not all boards can be!
4 grommets included in the kit..
These AVR programmers are based on Thomas Fischl's USBasp design and connect to your computer's USB port. Not only are they quite compact (70x20mm), but the design is really elegant. The USB interface is achieved by using an atmega8 processor and the rest is done in firmware.
Being an O..