With FC, OSD, PDB all integrated, Kakute AIO makes it simple and convenient to build up your drone.Only one VTX module is needed to make a complete set of FPV Racing Drone.Minim OSD integrated; MWOSD Firmware preloaded; OSD Config port available; OSD interface highly customizable according to you own needs.
2 oz Copper PCB ensures the 120A Maximum Continuous Current.Dedicated Boot button for easy firmware flashing.Reinforced solder pads for trouble-free direct soldering.Extremely low profile design.
Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on ‘BAT’ pad only!).PDB Maximum Continuous Current 120A.VIN + VBAT merged – A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.Filtered voltage output – output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX. 5v/3.3v RX selectable.
Cleanflight support (RACE target).BLHeli flashing supported by hardware.Raceflight and.Betaflight ready
1x Kakute Flight Controller
1x Quick Start Guide
1x 80mm XT60 connector wire
STM32F303CCT6(256kB flash) 32-bit processor
ATmega328P with Arduino Bootloader(minim OSD)
MAX7456 Monochrome On-Screen Display(minim OSD)
FTDI Cable Compatible Pinout(minim OSD)
High quality, gold plated PCB
Micro USB connector for programming
Dimensions: 36×47.5x7mm (includes USB in height)
Mounting Holes: 30.5mm square to center of holes