SucceX-D F7 TwinG Flight Controller (HD Version)

The SucceX-D F7 is designed to work seamlessly with DJI’s new HD FPV system.To make things as simple as possible, we have included a connector specifically for the DJI air unit, so installation should be a breeze. In additionally, we add the popular and reliable USB Type-C instead of Micro USB which makes connection easily.

Features

• Universal USB Type C connector instead of micro USB

• Plug-and-Play. No need to solder tiny wires.)

• Supports BLHeli pass-through for easy ESC upgrade and configuration.

• Designed to support DJI Digital FPV.

SucceX-D F7TwinG  SPECS：

- MCU：216MHz STM32F722RET6

- Gyro: 2x ICM20689

- Baro：YES

- Betaflight OSD：YES

- Blackbox: 32MB

- 5 x Uarts

- 8 x Motor outputs

- 8 pin 4in1 ESC port

- 4-pin VTX connector

- Betaflight Firmware：betaflight_4.0.5_STM32F7X2.hex

- CLI config：IFLIGHTF7_TWIN_G.config

Physical 

- Mounting hole：30.5*30.5mm，φ4mm with Grommets φ3mm 

- Size：36*36mm 

- Weight：7.5g 

Package included:

- SucceX-D F7 TwinG Flight Controller (HD Version)

NOTE:

The DJI Air Unit is not included in the package.

NOTE：

If you use your own DJI Remote Controller, you MUST update your firmware betaflight_4.1.0_STM32F7X2  configurator betaflight to 10.6.0 to set up and bind your DJI remote controller.

• Mode 1 setup：Reveiver tap -----> Choose “Spektrum / Graupner / JR (TAER1234)”
• Mode 2 setup：Reveiver tap -----> Choose “Frsky / Futaba / Hitec (AETR1234)”

DOWNLOADS：

• betaflight_4.1.0_STM32F7X2
• betaflight 10.6.0 configurator
• SucceX-D F7 Manual Instruction